P o q e t A d d r e s s F i x I n s t a l l a t i o n G u i d e Revision 3.0 January 6, 1996 There is a bug in PoqetAddress on the Poqet PC "Prime" (Model PQ-0181) that will make it appear as though your PoqetAddress data file is corrupted and your data is lost. In reality, your data isn't lost. It's just that if a particular byte ends up at a particular place in the data file, the PoqetAddress program is incapable of reading the data. The PoqetAddress Fix (PQTL2.COM) is a TSR (Terminate-and-Stay-Resident) program that corrects this bug. PRIOR TO INSTALLATION 1. Reset your Poqet PC by pressing the recessed RESET button above the backspace key on the upper right hand corner of the keyboard. WARNING!!: this will erase your D: drive, so make sure to copy any data you have saved there to another device. Either copy the files to another PC card using the DOS Copy command, or use PoqetLink to transfer the files to another computer. 2. Do a "Check Disk" of the card where your PoqetAddress data is stored. To do this, type "chkdsk /f " where is the letter of the drive where your PoqetAddress data is stored ("A:" for the left-hand card slot, "B:" for the right-hand slot, or "D:" for the internal RAM drive). TO INSTALL 1. Copy the file PQTL2.COM to one of the drives on your Poqet PC. 2. Execute the PoqetAddress Fix by typing "PQTL2". A short message should be displayed indicating that PoqetTL has been installed. The PoqetAddress Fix is now be installed in your system. This process should not need to be repeated, until your Poqet PC is rebooted either by pressing the CTL-ALT-DEL key combination or by pressing the hard reset button. If your Poqet PC is reset for any reason, repeat the steps listed above to reinstall the PoqetAddress Fix. ADVANCED HINTS - Copy the file "PQTL2.COM" onto an SRAM card that constantly resides in the Poqet PC, and add the command "x:PQTL2" to your AUTOEXEC.BAT file on drive D: (where "x" is the drive to which you have copied the "PQTL2.COM" file). By doing this, you will ensure that the PoqetAddress Fix will be loaded whenever you reboot the Poqet PC by pressing the CTL-ALT-DEL key combination. When the Poqet PC is reset by pressing the hard reset key, however, you will need to repeat the process of adding the command to the AUTOEXEC.BAT file. ADDITIONAL ASSISTANCE For additional assistance on this utility, point your Web Browser to .